• 4th Floor, Aims Prospero, Off.
    Atladara Padra Road, Vadodara,Gujarat, India -390012
  • +91-9909964912
    info@aopl.net.in
CLASSIFICATION

ASME.BPVC.II-C.SFA5.1 E6010 | SFA5.1M E4310 | UNS W06010 | CSA W48-01 E4310 | ISO 2560A E35xC21 | ISO 2560B E4310

CHARACTERISTICS & APPLICATIONS

ífíl-61 electrodes are characterized by a deeply penetrating, forceful, spray-type arc and readily removable, thin, friable slag which may not seem to completely cover the weld bead. Fillet welds usually have a relatively flat weld face and have a rather coarse, unevenly spaced ripple. The coverings are high in cellulose. Because of their covering composition, these electrodes are generally described as the high-cellulose sodium type.

These electrodes are recommended for all welding positions, particularly on multiple pass applications in the vertical and overhead welding positions and where welds of good soundness are required. They frequently are selected for joining pipe and generally are capable of welding in the vertical position with either uphill or downhill progression.

The majority of applications for these electrodes are in joining carbon steel. However, they have been used to advantage on galvanized steel and on some low-alloy steels. Typical applications include shipbuilding, buildings, bridges, storage tanks, piping, and pressure vessel fittings. Since the applications are so widespread, a discussion of each is impractical. Sizes larger than 5.0 mm generally have limited use in other than flat or horizontal-fillet welding positions.

These electrodes have been designed for use with dcep (electrode positive). The maximum amperage that can generally be used with the larger sizes of these electrodes is limited in comparison to that for other classifications due to the high spatter loss that occurs with high amperage.

Storage and Drying Conditions: Ambient temperature.

CHEMICAL COMPOSITION OF WELD METAL

C

Mn

Si

P

S

Ni

Cr

Mo

V

Mn+Ni+Cr+Ni+V

0.20

1.20

1.00

NS

NS

0.30

0.20

0.30

0.08

NS

Single values are maxima, except where specified otherwise.

ALL-WELD-METAL MECHANICAL PROPERTIES

Tensile Strength, MPa

Yield Strength, At 0.2%

Offset, MPa

Elongation, %

Charpy V-Notch Impact at

-30°C, Joules

430

330

22

27

Single values are minimal.

ELECTRODE SIZE & WELDING CURRENT

Diameter, mm

Length, mm

DCEP, Amperes

2.50

350

40-80

3.15, 3.20

450

75-125

4.00

450

110-170

5.00

450

140-215

WARNING : Safety and health information is available from many sources, including, but not limited to Safety and Health Fact Sheets listed in A11.3, ANSI Z49.1 Safety in Welding, Cutting, and Allied Processes published by the American Welding Society, 8669 Doral Blvd., Suite 130, Doral, FL 33166., and applicable federal and state regulations. The Safety and Health Fact Sheets are revised and additional sheets are added periodically.